Netro Inc
Actualizado 2020-11-04 00:49:22 UTC
When Sprite finishes running a watering schedule, it will send a confirmation to the cloud server. In this way, the could server knows whether the schedules are correctly executed or not.

The exclamation mark means the cloud server did not receive the confirmation from the device. There are two possible causes:

1. the device is not powered up when it was supposed to be powered up to run that schedule. Therefore, the corresponding zone is not watered (what is why we use the exclamation to alert users)

2. the schedule run fine but it was during a temporary network outage or exception so that the confirmation cannot be delivered to the server. Wireless connection can be unstable for a short peroid time so it is not uncommon to have a glitch in the communication.

If the schedules afterwards are all correctly run, it could just be a temporary network issues. But if that happens a lot please check the WiFi signal strength. If you use a WiFi extender, please make sure it is connected to the main router stably.

Thanks,
Netro Support
Ver: 2265    Me gusta: 0


ducati1198804
2020-11-05 02:50:18 UTC  
Would the exclamation mark show it the temperature was below the low temp setpoint? Like if it didn't run because it was too cold outside?
Netro Inc
2020-11-10 00:50:14 UTC  
Dear customer,

The temperature restriction will display on Schedule page but it will not be marked with exclamation mark.

Thanks,
Netro Support

geddeda geddeda
2022-06-12 02:31:55 UTC  
cialis caida cabello https://newfasttadalafil.com/ - Cialis Qxapti If there is widely metastatic or incurable gastrinoma debulking surgery and chemotherapy are indicated. T wave inversions may be present in the following situations Myocardial ischemiainfarction Pericarditis Cardiomyopathy Intracranial bleeding Electrolyte disturbances acidosis LBBB LVH Small T wave inversions may be normal in the limb leads. cialis generic Qsqhim https://newfasttadalafil.com/ - buy cialis online overnight shipping