I have an issue/conflict with the watering adjustments for the sensors and the Smart Zone Sheduling
I have seen something weird.
-
I Have set up the Watering Adjustment for sensors the following I describe o be sure about the problem
-
Moisture to Skip watering 50%
-
Moisture to Add watering 30%
-
Duration 5 minutes (only) -- it is a check
-
The Smart Zones are st up the following
-
Smart Zone - enabled
-
Mode - regular
The watering run today only 5 minutes, when the smart schedule defined by the system was above that. As you can see, tomorrow watering says different time runs per zone, but it will run a maximum of 5 minutes. This means that the sensor configuration overrides the Smart Zone. And it should not.
As far as I understand the Watering adjustemt is to add EXTRA watering when needed based on the moisture level. Attached picture
Prior to this setup I had the Duration for Watering Adjustment for 15 and 10 minutes, and you can see in the past days runs, that always run for 15 -10 minutes depending the zone/sensor. - Attached picture
In previous weeks, it was working fine and adding extra watering when need it to keep the moisture levels.
Any idea?
I DID THE CHANGES PROPOSED BY NETRO and it is not working
Take a look the screen shots
Zones 3,4,5 it is below the 30% trigger