Can you change the order of zones in a current program without having to create a new program?

Hello,

My system is not working. When I run a valve test, it shows all valves are normal but the master valve has an open circuit error. I have checked all the wires and there is not voltage at the wires at the valve itself. I used a volt meter at the Netro controller and there is no voltage coming out of the controller for the master valve. Any suggestions? 

Thanks, 

Matt

I’ve had the controller since winter so I wasn’t using it much in the winter. When I switched it to smart modes it seemed like it watered all day, multiple times a day. Is this just because it’s the initial watering in smart mode? If it’s a one day thing that’s fine but way too much ongoing. Also, on the averages it says 9 minutes every three days but it watered for over 15 minutes per zone several times that day. Thanks 

I set up all of my zones for smart watering today and it looks like it will be running all day. On zone 1 it must have watered 5 times (close to an hour total) even after it showed 100% saturation. Do i need to adjust some settings? That is way too much water for 70 degree weather in April. 

Thanks,

Matt