Hi.  My Pixie shows a Soil Moisture reading that changes over time, but it doesn’t have a Whisperer connected to it.  It seems to influence the watering frequency.  When I look at the watering schedule, it’s supposed to water every nine days, but instead it’s watering every three days.  Is this normal?  

I was looking on the preference section and see that we can select one of this. By default come with expectation selected. Wich is better?

I wondered if there are any Metro Omaha Landscaping Companies on this forum. 

Really liking the Netro Pixie, keen to pick up the whisperer. How do i get one in the UK. Shipping from the states is expensive?

Will the Pixie work with the Whisperer without needing a bridge?

My app is showing scheduled runs for morning and nights that I set up using a repeating program. At the time they are supposed to run they just saying loading the entire time. After they don’t run I can do a manual run through the app and it works fine. Any suggestions?

Looking to purchase a couple of whisperer sensors, and can’t really justify the $60 price.  Any discount codes/discount for multiples available?  Any money back guarantee if not satisfied with the whisperer?  

Hi Netro, I have fruit trees in clays soils and I have the whisper sensor helping me monitor the water. I have two issues right now. One is the sensor does not seem to detach much change in the moisture content in the soil, even immediately after an hour of watering. The other issue is I am getting run off during each watering cycle but I cant figure out how to spread out the watering or reduce them without going to a manual setting. Can you help me? Thank you!

Hello. I have restarted my netro 16 after winter. First it connected ok and after a power lose i stopped connecting to wifi. I have tried everything. The light is solid as if is connected. Plese help. Thank you

Hi!

My pools water fill line is connected as a zone on my sprinkler system. I would like to trigger turning on and off a zone based on a zwave switch status. Can this be done, or should I return my netro for a different system? It looks like netro does not have api access, and IFTTT is extremely limited. Thanks

I only have 2 zones.  1st zone is programmed for only 2 days per week while the 2nd zone is programmed everyday and at a different time then the first zone.  However on the 2 days the first zone comes on, the second zone does not despite be programmed to.  As mentioned the on times are completely different.  

It is offline and has no lights.  It it inside the garage and has had no environmental changes. 

After 4 months of non use over winter, I cannot restart my Netro system 

1 sec  blinking of light and have pressed reset button but still get  message “off line” and blinking persists.  

I have a good WiFi signal. 

Our controller has been working fine, and we had to replace some solenoids that were faulty. The controller is plugged into a verified live socket but no lights turn on. I can't hook up wifi, and it appears to be dead. 

Salve a tutti, come da titolo la app durante la configurazione con smartphone in questo caso un IPHONE 7 PLUS con iOS 14.4 non riesce a completare l’accoppiamento con Netro , ho riprovato con smartphone Android con successo.

Ho fatto presente l’anomalia anche all’azienda costruttrice, la quale ci sta lavorando.

Chiedo a qualcuno di voi se ha avuto lo stesso problema.

Hey Team,

Have one zone that is connected to drippers in an undercover area with hanging baskets

Need to set a regular schedule for watering in this area, that ignores restrictions for this area, but still applies for other zones. 

Is this available in the app at the moment?

Hello I would like to know how many electro valves I can open at the same time?

Thanks

Regards 

Hi, i would appreciate if someone could help me. I need to link the netro to the router without password, however the procedure need a password in any case: how can I do? Thanks for the support 

Can I turn Netro off on the app ?

I’m having problems with the runs zone one don’t go on and the other ones go on twice a day I’m trying to reset but I don’t know how thank you

Where is the MAC address found?