It seems if there is any chance of rain, the smart watering always skips the day. Even if I increase the threshold to the highest setting for both forecast or expectation it will skip the day. Can someone help me properly configure the smart watering feature? This Saturday, it's expected to rain less than my threshold in the evening, I would like the smart watering to water in the morning.
Thanks
Having trouble connecting when adding product.
I get to set 3 set up wifi
I connect to netro unit. I cannot switch back to netro app. When I restart app, it wants me to connect to home WiFi..
....
Never ending cycle. Thoughts??
TIA
I was told by support a few months ago that notifications will be included in the next release of the netro application.
I was included as a beta tester for the new version but I don't see any option for notifications when the system start or stop watering the zones.
It was or wasn't included?
Netro Whisperer sensor throws misleading and confusing data.
Hi, I’m moving and leaving our Netro system at our old house. I just need to know if it will continue to water when I cancel the internet service for that house?
I just find it alittle ridiculous to pay an internet bill for only the sprinkler system to run.
I am putting down some new sod Thursday. My last controller had a new lawn setting that ran for 15 minutes four or five times during the day. Is there a way to set that up with this controller/program? I think I'm running a sprite, netro version 2.5.3
Hi, I've been trying to integrate Netro with Google Home. The Pixie is connected in my Netro app. After logging into through Netro through my Google Home app. The following message appears:
No devices were found in your Netro account.
What is the issue?
Hi,
I have a whisperer that monitors zones 1, 2, and 3. Zone 1 is the primary zone. Because whisperer detected a moisture level that was too low it did an additional watering of 10 minutes. The strange thing about it is that it only watered zone 1 for the additional 10 minutes. Why didn't it water zone 2 and 3 when they have the exact same conditions and moisture levels. I had to go in and do a manual run to even out zones 2 and 3 with zone 1.
Also in the beta software when you try to switch from basic to advance watering or choose a different watering algorithm you get an error message.
How can I set the Netro up to water only on two specific days - the same days each week?
I removed an older controller and replicated the wiring when installing the new Netro. Everything appears to be correct? However, when watering is activated, the valves will fill up and vibrate or what not with water rushing internally. But the sprinkler heads don’t pop up and no water comes out. Any help here would be greatly appreciated. Thanks!