Instructions about Replacing Rainbird System

Netro Support
Updated at 2019-03-20 08:06:44 UTC
Topic: Installation

Replacing Rainbird system



This page lists some instructions about replacing the common types of Rainbird system with Netro smart watering controller. 




Example 1:


 The common wires which should be connected to the C slots in Netro.

The Sprite controller does not need the ground wires. It does not need the rain sensor either. You can leave the M slot unconnected. 

Example 2:



The COM wire goes to any C slot in Sprite.

The M slot will be empty because you do not have master valve.

The two red wires on the left go to the two 24 VAC slots.

Others are straightforward.

Example 3:


1. the COM wire in RainBird go to any of the C slots in Netro

2. The 1-6 zone wires in RainBird go to Slot 1-6 in Netro

3. Use the power adapter coming with the package for Netro

Other wires you can disregard them.


Example 4:


12(blue) and 11(red) go to the two AC slots on the right side for Netro. 10(white) goes to any one of the C slot in Netro. 9(black) goes to the M slot in Netro. 8-1(red) go the ZONES in Netro. You can leave the green wire (GND) open. The two leads from the power adaptor go to the two AC slots.






View: 211    Follow: 0    Like: 0