not watering after installation

I installed two Netro Sprites to replace the previous controllers. The installation itself went fine, and I was able to verify that the first one waters the zones fine.


However, the second one does not water any zones. All the status indicators are fine, I hear the water getting turned on, and everything but no watering. What could be wrong? The wiring seems pretty simple. One common wire, 4 zone wires, and the power. All the wires are securely in. What are the ways to troubleshoot this?


Thanks in advance!

Answer From John Locke

4
John Locke
 Updated at 2018-12-16 19:40:34 UTC
Your first Sprite should have a spot for a second common wire.  Maybe try hooking up your second set of zones to that first Sprite then plug in the rest of your sprinkler wires.  I replaced two old digital timers with 1 sprite.  Sorry but that’s my only suggestion good luck.  
View: 1673    Like: 1

4
John Locke
 2018-12-16 19:41:48 UTC  
For clarification just plug in your second common wire and rest of your zones unless you have more than 12 zones.

8
Sangjin Lee
 2018-12-18 16:40:40 UTC  
Unfortunately two controllers are far apart so I can't hook up all zones to the working controller. I am going to see if I can manually open the valves and test it that way...